Answer / dwaragesh

It is a flame control method. this is applicable only for
tangentially fired boilers so that the burner can be tilted
+30 and -30 degrees. This is used to maintain the temp of
steam in the tubes.

This is a mechanical arrangement in which all the 6burners
on the four corners are tilted simultaneously

Answer / kiko

Burner tilting mechanism is done in the boilers to rise or lower the flame to control the steam temperature. It also helps in uniform burning of the fuels.

Answer / kousik karmakar

We controll the flame in the boiler.position have +30/-30 degree..its main use for re-hit temp controlled.

what is interview question for power plant

3 Answers   Emerson, IOCL, SBPIL,

---

what is the difference between compensated & normal drum level in boiler drum?

0 Answers   ARS,

---

why airtel use + 24 volts and other operators use -48 volt

0 Answers   ABC, Airtel, INDUS, Reliance,

---

explain(why) with circuit for pick up of restricted earth fault protection due to external fault

1 Answers  

---

whatis means of PPA & FSA OR SFA in power plant operation

2 Answers  

---

What happens if there is no HP and LP By-pass.

5 Answers  

---

What is A.T.T.?

4 Answers  

---

What are the turbine protections.

2 Answers  

---

In a thermal power plant ID Fans running with full load but boiler load is only 80 % give reason ?

9 Answers   Essar, Prumatech, Tata Power,

---

why seal air fan is used and where it is used and where is suction taken from

7 Answers   Bhel, ETO,

---

In one plant id fan and fd fan are used for boiler. boiler is used to heat water after some days they install one tank to heat water by hot flue gases coming out from boiler and then hot flue gases are used to heat the air coming from fd fan before leaving out from chimney . but hot flue gases are not coming out from id fan what might be the reason?

3 Answers   TATA,

---

In turbine. why they not use 320 oil?

1 Answers  

---