Answer / anuj tiwary

As the EMF of a transformer is defined by the following formula:
EMF= 4x(Form Factor)x(Flux)x(Frequency)xN
Where N= Number of turns of Primary Windings (integer)
Form factor = RMS/Avg = 0.70/0.63 = 1.1 (for a sin wave)
Frequency = 50 Hz (integer)
Flux= BxA (integer)

Thus, the EMF turns out to be a multiple of 11, like 110V, 220V, 33 kV etc

how does a submersible pump work..?

0 Answers  

---

some practicle study shows that the reactive power at the receiving end is not equal to the reactive power at the sending end.But according to theory the reactive power is exchanged by different parts of the network – capacitors and reactors permanently, but is never consumed or produced. Then Where that reacrtive power loss occuring?is there any formula to calculate reactive power loss?

3 Answers  

---

what is the formula for transformer oil?

1 Answers  

---

How to select the proper VSD to operate high inertial load

0 Answers  

---

What do you mean by a current transformer?

0 Answers  

---

3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?

0 Answers  

---

One B.O.T Unit ??

10 Answers  

---

in small capacitor we use uf( micro farad) and in big quantity we used kvar. i want to know that in 1 kva how much will b uf(micru farad).

2 Answers  

---

ELCP USE IN 3 PHASE SUBMERSIBLE PUMP? THEN USE 3 POLE 0R 4 POLE?

4 Answers  

---

what is need of air gap in expansion section in busbar?

3 Answers  

---

DISCUSS THE SHAFT MOUNTED D.C. GENERATOR ,BASED ON EXCITATION SYSTEM IN ELECTRICAL SYSTRM

2 Answers  

---

Is it recommended to apply H.pot test for new cables segments after terminations or joints, however, this cable has been tested before at the manufactor by the vendor ? or only we can apply megger tests ?

1 Answers   Centroid,

---