Interested to Buy Any Domain ? << Click Here >> for more details...
why the measure taken in multiplication factor of 11for
voltage like..
110V,220V,440V,1.1KV,6.6KV,11KV,33KV,66KV,110KV,132KV,220KV
- 1 Answers
- 6537 Views
- Vijai Electricals, I also Faced
- E-Mail Answers
Answer Posted / anuj tiwary
As the EMF of a transformer is defined by the following formula:
EMF= 4x(Form Factor)x(Flux)x(Frequency)xN
Where N= Number of turns of Primary Windings (integer)
Form factor = RMS/Avg = 0.70/0.63 = 1.1 (for a sin wave)
Frequency = 50 Hz (integer)
Flux= BxA (integer)
Thus, the EMF turns out to be a multiple of 11, like 110V, 220V, 33 kV etc
| Is This Answer Correct ? | 27 Yes | 2 No |
Post New Answer View All Answers
What are the main parts of central chiller plant? Explain the function of each stage.
What is the use of iron core in a transformer?
What is slip in an induction motor?
magnetizer priciple
what is high and low cut off voltage of BB and DG at SPS????????
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?
As a electrical engineer.. what are the basic norms should follow in transformer oil testing.. 1.What is the Electrode type? 2.How long time you will give for oil testing?
what is mind in cable
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
How we can calculate the Amps for the cable Ex:- For 1sqmm wire how many amps we can draw (calculation)
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
What are the specifications for getting approval of Substation?
what does vector group Dyn11 tell us? also tell me how will u differentiate between phase lead and phase lag thru this vector group
how we calculate electrical load on a building according to area?
