Answer / selvakumar

The resistance of material will change per degree of temperature change,RTD is a positive temperature Co-efficient i.e resistance value will increase whenever temperature increases.
At 0 degree celsius Pt100 have 100 ohm,resistance will increase by increasing temperature .
To calculate R-R0/R=alpha*(T-T0)

Answer / nitish katoch

Resistance will increase at 1000 ohm per degree celsius for
pt1000

why 4-20 mA signal is preferred over a 0-10V signal

17 Answers   Sofcon,

---

why we are using drum level control valve air to close?

0 Answers  

---

how to convert cubic metre per hour to newton cubic metre per hour

0 Answers  

---

what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...

2 Answers  

---

hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel

0 Answers  

---

p=hdg,please explain these parameters?

7 Answers  

---

What are the types of control valves available

0 Answers   CCIE,

---

in split range control valve,two valve should be in two different line and that should have some distance,and we have only one positioner feed back link.so how we connect one feed back in two control valves?if you have picture please forward me.my email id kb.syamkumar@gmail.com

2 Answers  

---

what is the deferance between LCN and UCN.

1 Answers  

---

Describe the function of Accumulator into the Pump

0 Answers  

---

1. What means HART communicator / where it is used / how to use it? 2. Types of Thermocouples and its temperature ranges / output of thermocouple? 3. Types of RTDs and its temperature ranges / output of RTD? 4. Idea about Temperature Transmitters? 5. Difference between Analog and Digital signals? 6. Difference between “2 wire” and “4 wire” system / instruments? 7. Difference between “Potential” and “Potential free” contact? 8. Types of flow meters / transmitters? 9. Types of level transmitters? 10. Difference between “Power/Control” cable and “Instrument” cable? 11. What means “shield” and “screen” in cables / how it is useful? 12. Draw a schematic of closed loop circuit of flow / level / pressure / temperature? 13. Idea about calibration of Control valve / positioned / I/P? 14. How to bypass a digital/analog signal in PLC/DCS by hardwire and software?

6 Answers   JSL,

---

admittance level sensor meaning?

2 Answers   CGL,

---