Could you explain to me the enraf (servo gauge) mechanism. How it works ? and how it is working on archimedes theory while it's not immersed into the surface? and how can we calibrate it ? Thanx

1 Answers  

---

what is the deferance between LCN and UCN.

1 Answers  

---

how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.

0 Answers  

---

How does milli volt is created in themocouple?

2 Answers   Jaypee,

---

HOW TO CHOOSE FREAQUENCY IN FMCW TYPE RADAR INSTRUMENTS. DESIGN BASIS OR DESIGN CALCULATONS ?

0 Answers   Chevron,

---

1. What is the main differences between GE Mark IV and Mark V Turbine Control System? 2. what is the main differences between GE Mark V and Mark VI?

2 Answers   GE,

---

how u measure dp in dp tx? how u calibrate a dp tx?

3 Answers   Invensys,

---

I am a electronics and instrumentation fresher trying for a job in IT sector. what do need to prepare for the interview?

2 Answers  

---

What is controller? What is transmitter?

1 Answers  

---

My question may be very basic or childish but this question still persists in me, someone plz help me 1.why do we go for differential equations to analyze a system? 2.why do we solve it using matrices, is there any specific reason for using matrices other than the stories like it is simple,faster etc.

2 Answers  

---

If the average power during generation is zero, why do the analog meters have + and - ?

1 Answers   Siemens,

---

Wht is Dry Leg Calibration and Wet Leg Calibration?

2 Answers  

---