Answer / nitin diwan

Main Diffrence in between M-IV & M-VI is called the SIFT
TECHNOLOGY then meaning of this technology is that if there
is two diffrent alarm in two diffrent Processer i.e. X & Y
or X & Z the controller (M-IV) will give the trip command
to the turbine but in M-VI controller the same dignostic
must be in the both cummnicator then the controller givs
the trip command to the turbine.

Answer / aurelia smith

I worked for a public utility in Moncks Corner, SC.

One of our power plants has upgraded from a GE Mark II to a
Mark VI. We have the old Mark II cabinets with all the
components/circuit boards still in tack as well as all the
surplus inventory. According to your website your company
provides support for this system. Would you be interested
in purchasing? If not, do you know of a market that we
might use to advertise and sell?

what is the input to be given digital temp controller during the the calibration time?

2 Answers  

---

What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?

0 Answers  

---

Why drum level range is given -500 to 0 mmwc pls give me that answer

1 Answers  

---

hello i'am samad.Any one Can help me! How to calibrate Vaccum Transmitter DP Type range 0 - 50 mbar abs by hand pump calibrator.

4 Answers   Bharathi Cement,

---

If we increase only P what will be controller action ?

0 Answers   IMECO,

---

What is the main three inputs of DCS?

1 Answers  

---

why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V

0 Answers   Hospira,

---

what is the difference between Cv and air consumption? why the customer needs Air consumption details?

0 Answers  

---

How can we loop powered for a transmitter.How we can do wiring

1 Answers  

---

(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.

0 Answers   ADMA OPCO,

---

Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...

0 Answers   Adgas, GAIL, Oil India, ONGC,

---

why we use negative 24vdc to a proximeter

4 Answers   KNPC,

---