Instrumentation symbols interpration, P& ID, Logic diagram
analysis, Electrical drawing analysis.
No Answer is Posted For this Question
Be the First to Post Answer
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
What is the GK Value in Flowmeter?
What is the difference between EPROM & EEPROM.
What is SLPC & MLPC? How it works?
how to draw a flowchart for swapping two numbers using bit wise operators?
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
In apron feeder how TPH is calculated?
How to find out the current of two motors having same power consumption but different RPM?
Questions on flow meters,few questions on HART protocol,
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
what is the diffrence between plc&dcs
4 Answers HCL, Hindustan Zinc,
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)