please tell no. & add. of consultancy who recruit me in
power plant as instrumen engg. present i m working in
power plant as ass.t instrument engg.
thanku mahesh 09226562826
No Answer is Posted For this Question
Be the First to Post Answer
What is surge and how is it prevented.
how does we do bench calibration of a differential transmitter.
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
How many types of sensors are used in instrumentation & what are names
why we are using MARSHALLING PANEL? what is the role?
difference b/w single acting and double acting actuator by using application only?
hi... i'm about to learn siemens plc i came across following question in my mind ... plr ans 1. hw motor operated by plc 2. hw drive operated by plc explain dis by both ladder logic diagram and hardware config , connection
What is meant by Fail Safe Condition in PLC?
what is zero trim and span trim?. at which problem we need to use this?
I have observed in field instrumentation work... I remove the fuse of an analog transmitter then it shows 7.75 kg/sq cm (which is practically wrong value)in DCS and when put the fuse it shows 0 in dcs. Then cheach the field transmitter termination and found moister. clean that and then it shows 1.1 kg/ sq cm which is right value. Please describe the above phenomenon.
IF ASK IN THE INTENVIEW WHAT TYPE OF BMS YOU USE?
What is cut off relay? And why use in PLC and DCS?