Answer / Parul Sirohi

Calibrating a pneumatic controller involves setting its operating parameters to ensure accurate and consistent performance. The exact process can vary depending on the specific type and model of the controller, but generally includes the following steps:nn1. Disconnect the controller from the system and power it off.n2. Set the air supply pressure to the manufacturer's recommended level.n3. Adjust the controller's adjustable components (such as springs or valves) to their factory-set positions.n4. Power on the controller and verify that it is responding correctly to changes in air pressure.n5. Perform a series of tests to measure the controller's performance, making any necessary adjustments based on the results.n6. Once calibration is complete, reconnect the controller to the system and ensure it operates properly under normal operating conditions.

WHAT ARE MAIN DIFFERENCE BETWEEN DCS AND SCADA?

7 Answers   ABB, Gold Fields, Rand Water,

---

If the vibration probe near to the shaft,then output voltage will be decreased r increased?How?

1 Answers   Amtek, Hamsco, IJT,

---

how to calibrate load cell

1 Answers   Siemens,

---

What is force balance principle? State some of its’ advantages.

1 Answers  

---

pls send me the 10 years technical question papers of NTPC AND BHEL

15 Answers   Bhel, NTPC, ONGC, UCE,

---

what is weighfeeder

2 Answers  

---

why do 4 mA serves as 0% not 0 mA?

10 Answers  

---

In your own words, would you expect an ultrasonic level device to work better in a pressure vessel with a high pressure or a strong vacuum, and why?

1 Answers  

---

what are the on/off valve precaution?

1 Answers   Reliance,

---

Condensation within a sight glass? Would you expect there to be more problems when using a sight glass if there is condensation on the inside or the outside of the glass, and why?

1 Answers  

---

How we will check whether the proximity, which we have is either NPN or PNP, if no data sheet or manual or any details is available to us ???

1 Answers  

---

role of electrical engineer in the instrumentation industry

1 Answers  

---