Answer / hams

Key phasor always used to give pulse triggering in each and every rototion of the shaft.

Answer / mst

it is used for determining a phase angle.
during trim balancing of turbine it is used to identified certain vibration in a specified angle.

Answer / raj

Keyphasor use foe turbine RPM measurement

Answer / vikrant kumar

IT USED TO ELIMINATE MANY POTENTIAL PITFALLS AND HELPS TO GIVE GOOD DIAGNOSTICS. ITS GIVE VISUALIZATION OF PROPER NOTCH AND GEARS POSITION.

Answer / jong oconer

keyphasor is used for speed monitoring.

Answer / umapathi r

Keyphasor is used for reference signal in absolute phase and also measured the shaft speed

Answer / unaise

keyphasor is used to insert vibration sensor or proximeter prob

what is difference between Floating D.C.Voltage and Fixed D.C.Voltage?

2 Answers  

when an eddy current probe is installed inside of a turbine or compressor in case of probe problem same as:crash of head of probe,changing the scale factor because of low measuring gap(physical gap is ok(example=1.14mm)but voltage is reduced(example=-6 volts),is any way to check the probe,when the ohm of probe is ok.thank you,(Karim Tavakoli)

1 Answers  

how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?

1 Answers   United Phosphorus,

what is plc?

27 Answers   HPCL, KRL, Noor Company, Petrochemicals, SS Automation,

what is the principle of ultrasonic flowmwter and radar type flowmeter?

4 Answers  

what is a mapping in plc & dcs

1 Answers   Arctern, ARM Cement,

Explain level troll principle & interface level measurement.

1 Answers   ADMA OPCO,

why? Boiler furnesh pressure transmitter mount in boiler top and it's impulse line is in bottom of the boiler. Aneybody kindly tell me this reason.

1 Answers   Birla,

pressure switch range 0 to 2bar.i have to install from ground level to 5 meters height.what is the formula the to increse the range ? and every 1 meter how much pressure should be add ?

3 Answers  

what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.

1 Answers  

how many mmwc are eual to 1kg/sq.cm & can we calculate mmwc into tph?

2 Answers  

What is the difference between dry contact and wet contact?

2 Answers