Answer / ravinder tanwar

Mapping is the process of assigning the addresses to the
controller for I/O integrity for e.g in GE fanuc PLC if we
have to assign a single address for AND combination of two
inputs then we simply connect these two inputs in series
and assign a single address for for combination of these
two inputs means (%I0001---%I0002----------%M0003)
Here I in input from field and M is memory mapping address
assigned for combination of these two inputs

What is instrumentation control?

0 Answers  

---

What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?

0 Answers   Jubilant,

---

suppose, after calibrating a transmitter we fixed it in a process line. At live zero condition the Tx shows 4.5 mA. what should we do to make the Tx show 4 mA? If we adjust zero, will it not affect the calibration?

4 Answers   ABG Shipyard,

---

I have a orifice installed in plant which is design for 0~100 inH2O for 0~80MMSCFD, now due to process change the maximum flow is change to 120 MMSCFD so for this new process value what will be the DP across orifice.

1 Answers  

---

ALL INSTRUMENTS WORKING PRINCIPLE.

3 Answers   Blanco, India Cements, TVS,

---

Explain level troll principle & interface level measurement.

1 Answers   ADMA OPCO,

---

field bus transmitter calibration procedure tell me

0 Answers   BAP,

---

can you give some devices that measure directly the mass flow rate.

1 Answers   Takreer,

---

1 > HOW TO MEASURE INTERFACE LEVEL 2 > DIFFERENCE BETWEEN RADAR & ULTRASONIC LEVEL TRANSMITTER

3 Answers   Atul Auto,

---

EXPLAIN PROPOTIONAL INTEGRAL DERIVATIVE CONTROL ACTION?

1 Answers  

---

what is meant by calibration

3 Answers  

---

what is output of FOUNDATION FIELD BUS transmitter

0 Answers  

---