What is the difference between dry contact and wet contact?

Question Posted / vasantharajd

2 Answers
16078 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What is the difference between dry contact and wet contact?..

Answer / chandramauli sinha

Dry contact is volt free contact. for e.g- relay contacts .

Wet Contact is voltage at the relay contacts.

Is This Answer Correct ?

29 Yes

3 No

What is the difference between dry contact and wet contact?..

Answer / jith

dry contact is the one which doesnot have internal soure of
energy

Is This Answer Correct ?

9 Yes

3 No

Post New Answer

More Instrumentation Interview Questions

How RAL(Rotary air lock)works in cement industry?

0 Answers Jaypee,

Hello Friends do you know this answer of this Question? Which color you would use when there is Somthing not correct or need to change In P&ID? i mean color that use for highlight that need to update in P&ID. Yellow Highlighter ? Red color ? Blue Color ? Appreciate for your answer. Thanks Blue Color

2 Answers

What is difference b/w absolute & gauge pressure? EXPLAIN

2 Answers IFFCO,

Make Heater Process Logic.

0 Answers

What is the basic difference between 2 Wire, 3 Wire and 4 Wire RTD

2 Answers

What does a fire detector detects?

4 Answers GAIL,

How much should be the values and/or percentages of these given below factors for a good controller ? Steady state error Delay Rise Time Overshoot Peak Time Settling Time Damping Oscillations & vibrations thanks

1 Answers

find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s

0 Answers

Someone please do mail me some instrumentation questions for Hindustan Petroleum test to avinalexander@gmail.com .Really would be gateful if someone could help me

3 Answers HPCL, Immersion, IOCL,

2. What is ultrasonic flowmeter?

1 Answers

what is the conversion factor for nm3 to kg/hr in air flow

4 Answers

capillary type tranmitter using remote seals and capillary tubes filled with liquid of known of known density so if you wanna callibrate it just close block valve just before capilary @ high side & connect druck apply it's calibrated range pressure as normal calibration ensure low side block valve must be closed & if you asking commissioning so this is not a DP type pressure tx so simple if you wanna put in servie this tx just open high side block valve & than low side block same way i do it but still transmitter showing -13 ma.just tell me what i want to do ?

1 Answers Gasco,

For more Instrumentation Interview Questions Click Here