Interested to Buy Any Domain ? << Click Here >> for more details...
What is the use of keyphasor in turbine.
- 7 Answers
- 35676 Views
- Hindustan Zinc, R&D, I also Faced
- E-Mail Answers
Answer Posted / mst
it is used for determining a phase angle.
during trim balancing of turbine it is used to identified certain vibration in a specified angle.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
How to calibrate an pressure gauge with yantrika test bench?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
can we create an interrupt in plc through scada?
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
which type of filter gives the constant phase characteristics?
Define cryogenic?
draw the block diagram of a level transmitter ?
which processor is used in dcs.
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
How does work A temperature valve or fv control valve in process plz brief me
what will the sending unit in the fuel gauge utilizes?
