Answer / haridass

T4 temperature is the point where the temperature is
measured in the turbine at 4th position.

1. Ambient temperature (Outside enclosure)
2. Gas generator inlet temperature
3. GG air outlet temp (Where P2 measures)
4. HP to LP (PT) turbine temp (After fired)

This is used to measure the temp of hot gas passes out from
the HP turbine, which has left side 4 probes & right side 4
probes.

It trips the compressor (Turbine) when there is 120deg c
difference between left & right avg.

It trips comp when avg temp goes more than 740 deg c (due
to air-fuel ratio).

These informations are partically observed from MAN TURBO
THM 1304 gas turbine.

Why we use 4 to 20 mA, (This is International Standard) instaed of this can we use 4-16, or 4-24 or 3- 15 or any other range

13 Answers   ONGC,

---

what is radar type level transmitters and its basic principle and how to calibrate it

4 Answers   ABB, Inovonz,

---

Pls can anybody tell me how much memory plc's has?in byte or in Kb

2 Answers  

---

Any Transmitter Range (Span value) start from 2?

1 Answers   Exxon Mobil,

---

How to Calibrate Transducers? Can you give me a step by ste procedure?

1 Answers  

---

How earthing can be checked????

0 Answers  

---

plz exlain the dcs system of ABB sympony hamnony

1 Answers  

---

what is Pre- commissioning.

5 Answers   Saipem, Takreer,

---

Draw symbols of the following :

0 Answers   CCIE,

---

1)What is the suitable MOC for flow meters working at temperature between 200 - 250 cen. 2)In which application the mass flow meters are not advisable 3)Is it advisable to use radiation type or radar type instrument for non contact application

1 Answers  

---

HOW WE ARE DECIDING WHILE PROGRAMMING IN PID CONTROLLER THAT WE ARE USING HEATING OR COOLING???????

1 Answers   Eskom,

---

What is the difference between a PLC (Programmable logic controller) and DCS (distributed control system)?

7 Answers  

---