Answer Posted / haridass
T4 temperature is the point where the temperature is
measured in the turbine at 4th position.
1. Ambient temperature (Outside enclosure)
2. Gas generator inlet temperature
3. GG air outlet temp (Where P2 measures)
4. HP to LP (PT) turbine temp (After fired)
This is used to measure the temp of hot gas passes out from
the HP turbine, which has left side 4 probes & right side 4
probes.
It trips the compressor (Turbine) when there is 120deg c
difference between left & right avg.
It trips comp when avg temp goes more than 740 deg c (due
to air-fuel ratio).
These informations are partically observed from MAN TURBO
THM 1304 gas turbine.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
Explain the burnout feature.
Why is the orifice tab provided?
What are the types of valves?
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
What is the reason PT speed not incresed in gas turbine?
why we are using drum level control valve air to close?
Which is the best field foundation bus. ( FF ) Yokogawa, Honeywell or others ?
how to calculate control valve bonnet size?? or how to select its material?
how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i
What are the maximum packet size of: a) HART b) Profibus DP c)Profibus PA d) DeviceNet e) Foundation Fieldbus
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
what will the sending unit in the fuel gauge utilizes?
State some of balance principle’ advantages?
What is stripper & spilitter ? Diffrence in this.?
send me last 5 years questions asked in rrb chennai, for section engineer