what is the principle of operation of tungstun bulb ??
Answers were Sorted based on User's Feedback
Answer / dilli babu
tungstun having high resistance.In tungstun bulb the tungstun is made into a conductor of very small area of cross section. due to the small are of cross section, the resistance will be increased. that too that small conductor is made into a small spiral to increase the length of conductor.
Whenever the cuurrent flows through the conductor there will be a eddy current loss. this eddy current loss dissipated in the form of heat. Due to the low area of cross section in the tungtun filament resistance is high. So the flow of the current is opposed and the eddy current also increased. So the filament becomes heat and the heat leads to gives the illumination.
Is This Answer Correct ? | 8 Yes | 2 No |
its based on Einsteins photoelectric effect
Is This Answer Correct ? | 0 Yes | 2 No |
last 5 year rrb allahabad junior engg electrial engg question paper
A transformer is used to light a 24volts,70watts lamp from a 240a.c main.The current in the main cable is 0.35A. Calculate, (1) The efficiency of the transformer. (2) the current in the lamp.
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
How can i learn to programme every VFD. Or is there any typical study to understand VFD programming.
what will happen to give a dc supply in ac motor?
What is the meaning of Insulation H for transformers????
how to flameproof electrical motor on the shaft?
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
what is reactive power?
For 300MW and over a distance 250 km, what voltage be selected? and no. of circuit?
EXPLAIN THE TRANSFORMER MAINTENANCE?