Answer / maheshc

Generator is coupled with with the diesel Operated Engine which on ignition produces the rotating of generator rotor and as per the Faraday law as the magnetic lines of flux get cut at definite time an emf induces in it.

Why grounding is generally done in supply end?

1 Answers   ISRO, OFBL,

---

What is the Difference Between the SCADA & PLC ? Both it also control and Supervise Then what Special in Scada & PLC?

1 Answers  

---

What is the purpose of reactor in over head transmission line.Can you any explain it.

2 Answers   Dr Reddys, L&T, Reddy Labs,

---

What is meant by (2 x 185) AYFY cable

3 Answers   ONGC,

---

we have 3*1 MW generator one NGR is common for all it will be selected during paralle our problem is two generator ca be paralled but when slecting third one we need to close NGR selection on third one other wise voltage not matching why?

1 Answers  

---

why two windings are using in single phase AC motor

3 Answers  

---

If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?

0 Answers  

---

What are the tests to be taken on a transformer and generator?

12 Answers   Honeywell,

---

what is the transformer

6 Answers  

---

Why 11KV PT Secondaries [(11000/1.732)/(110/1.732)/ (110 / 3)]are in star connection ? And why the same should not be in delta ?

1 Answers  

---

What is CBCT ? Why & Where it is used?

14 Answers   BCT,

---

instead of neutral can we use earth/ground to flow the current in the circuit

2 Answers   Infosys,

---