I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Co

I have a question, I visit 01 site and face a problem,
there is 2.5 ton Air Con working, when air con compressor
is running at that time rectifier voltages are increasing
upto 290-295 v and rectifier is giving main high alarm
(rectifier is APC single phase, before starting compressor
rectifier voltages was 230v. when air con is going off
rectifier voltages are decreasing smoothly at its actual
voltages 230v.

Load on Genset phases is this: Red-13.5 amp AC (Air Con
load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp
AC (telecom system load),
Genset phase to phase and neutral to phase voltages are
also ok.

These are 10 sites having same system and same rectifier
APC brand at every site 02 genset are working but the
problem is same at all these 10 sites.

What will be the reason behind???

Question Posted / wap

1 Answers
3817 Views
I also Faced
E-Mail Answers

I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air ..

Answer / k.prakashchandra

Neutral- shift due to load

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

what is difference betwen genrator and alternator?

3 Answers Tanfac,

why nutral and earthing wire connect with each other in main panel board.

2 Answers

i have 400/230v transformer and didnt done the neutral eatrhing. i connected one lamp to one phase and neutral to the earth. but the lamp is not glowing. again i connected neutral to earth and repeated the same. then the lamp is glowing. in the first condition i tested with a line tester also, at that time the tesrer is glowing what is happening i dont know can any one help me?

1 Answers

Dear all i want to know SEWA Electrical Supervisor Licence test Previous Year Questions ? If any body know please send to me zohairaukllah@yahoo.com

0 Answers

how to reduce the power consumption in office ?

6 Answers

how you can select circuit breaker for 2000kva transformer?

9 Answers TATA,

i have a Connected Load of 280KW and Maximum Demand of 224KW to one of SMDB under design with me. which criteria should i consider to design panel and main cables connected Load or Maximum Demand 1)Breaker rating 2)Panel Busbar rating 2)Incommer cable sizing (ignore Voltage drop)

1 Answers

Why we use series reactor in power system?

9 Answers Cadbury, HEG, Uttam,

How much current can 11KV line carry? What are the formulae used to calculate current across both side of transformer? Moreover I need to know can I connect 33KV line with transformer of 1600KVA? Details are: V=415, Pf= .9

3 Answers

WHAT IS THE MEANING OF CYWY

1 Answers

explain different types of d.c motors?

0 Answers

Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?

1 Answers

For more Electrical Engineering Interview Questions Click Here