IS there any effect of vortex in low pressure side of the
transmiter after the orific in feed water line? if yes
then what is the calculation?
No Answer is Posted For this Question
Be the First to Post Answer
Transducer Input 0 to 230 v ac Output-0 to 10vdc Receiver Input 0 to 10 vdc and Output 4 to 20 ma How?
How to carry out hot loop checking of closed loop pf temperature control valve & temperature transmitter?
where proximity sensor installed on tank in loading arm application
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
why does mA signal preferred for signal transmission?
why vortex flow meters and electro magnet flow meters are used in water treatment plants
My flow transmitter range is 0-1000mmwc.DCS range is 0- 100m3/hr.What is correspond out put in terms of milliamps if my flow is 65m3/hr
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
which are types of orifice tap ?
hiii.... can any one provide me previous years question paper of hindustan petroleum for instrumentation engineering???
what is the differnt between open loop and close loop ?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.