Answer / carl_ellis

do a Google search for
allinterview 181560

This question was answered in that thread

Carl Ellis
Measure First

Answer / sivakumar.s

3 to 15 psi is not standard it is depend on valve spring range it is see in valve name plate

when the force applied on load cell the ohms will be varriying .and how its convert ohms to mv generate and have any formulae?

1 Answers   UETCL Uganda Electricity Transmission Company Limited,

---

what is ILD

1 Answers  

---

Why any transmitter signal is 4-20 mA only Why is started from lower range 4 mA and upper range is 20mA.

5 Answers   Edac,

---

I have a orifice installed in plant which is design for 0~100 inH2O for 0~80MMSCFD, now due to process change the maximum flow is change to 120 MMSCFD so for this new process value what will be the DP across orifice.

1 Answers  

---

Can anybody tell me application of PLC,DCS,SCADA.

3 Answers   Reliance,

---

---

what is droop in governer ,type of droop ,how it work

0 Answers   TATA,

---

i have height of stem drum level 1000mm.how i calculate the DP transmitter

2 Answers  

---

Why Flow measurement has to use Square Root

5 Answers   Hindalco, Petronas,

---

what is the thermocuple compensation circuit

3 Answers  

---

Can I calibrate the Electromagnetic Flow Meter on line and How.

0 Answers   SEWA,

---

You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground

1 Answers   EIT,

---

How does temperature bath work? How does coil gets heated only by applying some current?

0 Answers   Process Control Technologies,

---