Answer / satyajit sahani

Hi,
For pH transmitter you can use buffer solution in betwen
your pH sensor range.But when you are going to calibration
use buffer solution 7.00(Neutral)then any solution from
either Acid side(4.01)or alkali side(10.0)

Answer / a.mondal

Phosphates buffer solution is used

Answer / srinivasan

we are using the 4.7 10.based on the configuration like 4 to
20 ma.if 4 ma means 0 and 20 ma means 10.when we using the
ph 10 it will get 20 ma..

what is compensation in engineering and what is temperature compensation?

1 Answers   Binani, Yokogawa,

---

when i installed Allen_bradley_RsLogix_500_Pro_V_7.0,after installation it gives the fatal error.it need activation file.from where and how i can find its activation file.

6 Answers  

---

How can we loop powered for a transmitter.How we can do wiring

1 Answers  

---

why we use 0.2 to 1.0 kg/cm2 output in control valve

4 Answers   GNFC,

---

WE Know that different supply voltage of solenoid valve like 24,110,220 etc..how we check the solenoid supply is 24v or 220 NOTE: No specification at device.

2 Answers   OMV,

---

this site is owned by an nonsense

0 Answers   Bhel, Prolific,

---

what r all the closed loop used in boiler? for this related tell some web address..

3 Answers  

---

How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?

1 Answers  

---

Why we use mmwc unit for pressure

3 Answers  

---

Instrumentation engineer please reply me,I am electrical engineer ,what is the future in instrumentation dept {presently working (P&ID) Design} for me,whether good future for me as instrumentation department.what side can i get job in future

3 Answers  

---

Basic working principle of control valves

1 Answers  

---

there is one orifice plate already installed on 3" line, but my previous engineer(who is not working here) removed that tx, but now i want to take it in to the process, so now what i have to do now? flow fluid is hytherm oil of temp. 260deg & pressure is 3bar.

2 Answers  

---