Answer / subhasis1991

Its kind of length to be embeded inside some support like column or something.its calculated using IS 456 :2000
Page 42. 26.2.1

Now description of the equation is probably as follows..
let dia of a bar is = d; tensile strength = s;and shear strength is =t;and length embeded in a wall is Ld;;;;
So to keep the bar to resist from sleeping from support
upto it's tensile strength the condion would be
(Ld*(pai*d))*t=s*((pai*d^2)/4) => Ld=(d*s)/(4*t)...

Answer / vishal

It's 50 times dia of reinforced bar.

Answer / arvind rai

the best is 50D

Answer / syed abdul rawoof

For column lap length should be 45d and for slab and beam 60d where d is dia of bars in mm

Answer / keshav kumar

Basically the column is a compressive member and use the
high grade conrete, so lap lenth is less than Beam.

HOE TO YOU PLAN TO ACCHIEVE THE GOALS?

0 Answers  

how to caliculate required amount of cement and sand required for 1cu.m.

0 Answers   Allied Group, L&T,

what is the difference between stress and pressure??

7 Answers   Rites,

DESIGN PROCEDURE OF THE COLUMNS

0 Answers   TCE,

std heights of c.p fitting from ffl like health faucet,wall mixer,shower arm,european commod,wall hanging commod etc.

1 Answers   Maples,

Niti Aayog has recently chalked up an action to help India achieving _____ medals in 2024 summer Olympics after dismal performance in 2016 Rio Olympics? A)20 B)30 C) 40 D)50

1 Answers   HPSSSB,

i just want to know how much require sand and cement for 1 sq.mt including wastage. Please guide me as soon as possible. 

0 Answers   bsmcpl, L&T,

How to calculate density of 40 mm coarse aggregate, in mixing ration 1:1.5:3? Please explain calculation for density

0 Answers   Ansal Housing,

what is difference in chemical composition between fe415 and fe500

1 Answers  

what is the minimum reinforcement provided in beams,footings,slabs? what is the minimum soil bearing capacity to design a multistorey building

0 Answers  

what is meant by structural design?

0 Answers  

States some of the tool bars used in cad?

0 Answers