Answer / renjith raj knpc

Slope means the response of the pH probe..
Means from the slope the efficiency/ sensitivity of probe manipulated..normally for 1 pH slope is55mV...so for 9ph it will 2*55mV and for 7ph it will zero...etcc...

all questions related to instrument technician in any offshore oil and gas company.

0 Answers  

---

what should be minimum length and size of impulse line for steam flow orifice and feed water orifice? asked by sanjay parihar

1 Answers   Birla,

---

What is zener diode? What is voltage regulator?

0 Answers  

---

What is transmitter

2 Answers   GNFC, QNFS,

---

what is cems analyzer explain with principle and drawing ?

0 Answers  

---

---

what is the difference between Ethernet unmanaged and managed Switch?

2 Answers  

---

wht is snap action switch?where it is used?is there any diff between snap action switch and normal pressure switch?

1 Answers   ONGC,

---

i want the equation of this question. Tranmitter range is 120 mmwc and dcs flow range is 1700 nm3/hr. if i want to change dcs range from 1700 to 2400 nm3/hr then how much dp i have to enter in transmitter

2 Answers   GMR,

---

why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??

1 Answers  

---

Explain why use mmwc unit?

0 Answers  

---

wHAT IS BURST MODE IN TRANSMITTER?

1 Answers   Bhel,

---

What is the use of temperature compensation?

0 Answers  

---