Answer / george mathews

Hart communicator is both a calibration as well as a
communicating device. As when we connect the two connector
to the transmitter it first communicate with the transmitter
ang gather all the data of the respective tansmitter and if
needed we can recalibrate it to a new range using the same
hart communicator.

Answer / mugil

HART is a communicating device in transmitter.

Answer / haparmar

HART IS NEVER USED FOR CALIBRATION.

Answer / amarpreet

Yes,because communicating device is very harmful&it can
stop it for pass out.

flow transmitter range is 0 -500 mmwcc but the transmitter shows 12 ma for o mmwc instead of 4 ma ...how to solve this problem when we apply 375 mmwc it shows 16 ma

3 Answers  

---

If you calibrate a pneumatic pressure transmitter, how many adjustments are normally necessary or mandatory?

1 Answers  

---

We do have a problem in the company that is one PT connected to PlC which is mean 1 out of 1 in PLC system we do have the PAHH is 55 mbar and PALL 8 mbar with a timer of 15 sec for the PAHH the problem started when PAHH goes more than the set point which is 55 it reached up to 71 but due to timer doesn't trip . We force it and we checked everything nothing there . We replaced the transmitter problem still there the reading goes more than the 55 bar the range for transmitte is 0- 60 mbar . So we did loop check , aculaizing valve , wiring all are okay . What the possible causes for this ???

2 Answers   National Petrochemical Company,

---

HOW TO CALCULATE WAKE FREQUENCY FOR THERMOWELL???WITH OUT SOFTWARE..

1 Answers  

---

If we increase only P what will be controller action ?

0 Answers   IMECO,

---

Draw a great bridge circuit.

0 Answers   CCIE,

---

What is the difference between radar and ultrasonic level transmitter? Which method is best and more accurate?

8 Answers  

---

Transmitter reading is zero but in DCS showing one Bar what is the reason ?

3 Answers  

---

what is transducer?

13 Answers   Sofcon,

---

hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel

0 Answers  

---

How to fix back the valve actuator stem

0 Answers   SAFCO, Tarpon,

---

how to use K thermocouple instead E- type without compesation cable

1 Answers  

---