Answer / r.murugan

important closed loop in boiler side
1.Drum level control (single element control and three
element control)
single element control : only drum level
three element control : steam flow, feedwater flow, drumlevel

2.boilerfeedpump scope control,super heater spray
temparature control,hp heater level control,lp heater level
control,presure reducing control,dearator level control
o2 master control,

turbine side control: speed control (during start up),load
control,intial pressure control,exhaust temp control, load
drop control,oiltemp control,

open loop control based on unit capacity

Answer / ch amir islam

dear infact numbers of loops eitherr thz r open or close
depends on the required system & process.any how these
loops are used on demand of process.as relitively ur
question in which kind of system u want to ask about
COMBINE CYCLE POWER PLANT or OPEN CYCLE POWER PLANTS.open
loops depends on the system reliability if u want to check
morer parameters on ur HMI or at CONTROL DEVICE

what is the procedure of O2 analyser calibration?

3 Answers   Thermax,

---

the output of the common trasmitter protocol in qatar gas are the following

0 Answers  

---

Single acting ON-OFF valve. it is air to open. when sov energized , valve will be open, so during that if air fail then what will be the condition of valve ( open or close ) ???

4 Answers  

---

Explain how thw analog to digital converter works with the circuit diagram

0 Answers  

---

flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty

0 Answers   ONGC,

---

WHAT DO WE MEANT BY INSTRUMENT MAINTENANCE IN SOFTWARE SIDE.

1 Answers  

---

please explain about actuator action? direct action & return action ?

1 Answers  

---

What is difference between ESD and PLC please Explain me clearly.

0 Answers  

---

what is the different between plc and dcs ? I know full name of this two but I want to know what structure and working style and speed I/O capacity and controller difference?

2 Answers   L&T,

---

suppose in dcs range of a flow transmitter is 10t/hr what is dp for 50% in 2500mmwc

6 Answers   Chevron,

---

What is the working principal of Mass flow transmitter?

1 Answers  

---

how we calculate the range of flow from a dp?i mean if we have a dp,3810mm h2o.how much flow ranges we can use for this DP?

1 Answers  

---