given a processor batch of 1000 resistors moving on the conveyor belting in a

given a processor batch of 1000 resistors moving on the
conveyor belting in a large factory. the resistors is value
at 10k ohms each but when the resistors reach the quality
control, some of the resistor has been rejected caused by
failure in manufacturing.the high quality measurement is
used to determine the failure. describe the instrumentation
terminology in measurement of a system above with explaining
the important in:-
-reliability
-sensitivity
-repeatability
-precision
-range
-resolution
-linearity
-hysteresis
-error
-accuracy
(answer must related to the scenario above)

Question Posted / spartacross

0 Answers
1934 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Instrumentation Interview Questions

Absolute pressure is 700psi,what will be the gauge pressure?

1 Answers IFFCO,

What are the characteristics of Control Valve

2 Answers Ispat,

Please can anybody tell me the step by step procedure for calibrating the Pr,Lvl,Fl,Temp transmitter on process?

1 Answers

what is air to open and air to close control valve and difference btwn this...and how to measure milli amp by this...and what is the role of positioner and i/p converter in this..plz help me

2 Answers HCL, SOC,

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

0 Answers OPaL,

How can you convert an SR Flip-flop to a JK Flip-flop?

1 Answers

control valve in manual/auto mode huntting checked spring tention also it is ok.positioner also good condition & incoming inst air line also constant pr.kindly give us correct answer?

5 Answers Madhu Power,

why temperature transmitter is showing ambienttemp.but 21.5ma. alarm AO showing at the display &how to sloves this problem.

2 Answers

How to Calibrate Radar Level Transmitter in Field

0 Answers

How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?

0 Answers

what is difference between hart signal and analog signal (4 to 20 ma)

2 Answers Takreer,

please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com

0 Answers

For more Instrumentation Interview Questions Click Here