Describe a time when you anticipated potential problems and
developed preventive measures.
No Answer is Posted For this Question
Be the First to Post Answer
There are many type of control cable like pair,core,tried, What are defination each one
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
what is see back effect?
generally transmitter power supply having some range(12v to 35v) but the out put(4-20 mA) must same for given input.If we vary the power supply voltage then output mA also to be change according to V=IR. Is there any voltage regulator in the transmitter ?
why we are using perforted cable tray for control cable and ladder tray for power cable
if differential pressure created by orifice falls below vapour pressure of liquid flowing through it what will happen
What does it mean 3/2 sov
GWR radar transmitter working principle?
How Honeywell FSC is functioning and what is its purpose? Can we bypasa it and only use DCS instead of that.
in current transmitter why we use 4-20ma ???
If we increase PI controller what will be action.
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72