Answer / anil

above two ans are correct
Basic difference is
1.T/C is contact type temp semsing device.
Pyrometer is Noncontact temp sensing device.
2.T/C is used in where u r measuring a room temo, molten
metal bath temp, i.e. where u can insert it.
pyrometer is used where contact is not possible like
running hot sheets, metal strips like in steel industries

Answer / amsal

each has its own value.
Because pyrometer is used where t/c can not be used.and pyrometer can not take place of t/c.
pyrometer is used to measure the temperature measurment is done without contact or contact can be harmful like in foundries operations as anealing, tempering and melting etc,
there temperature range is higher than t/c range.
T/C is used in process industries commonly to measure temperature.where pyrometer cannot be used.

Answer / raju

Both as its own application and its useage
t/c can measure only upto particular range only depending
on the type of t/c were as pyrometer range will be more
than t/c, at the measuring range of pyrometers t/c will
melt more over for temp. between 1100deg its lots better to
go for t/c only if the contact is available and the range
above this its better to preffer pyrometer wether it may be
contact r non contact is available

Answer / prithiviraj

thermocouple is contact type measuring device which can be used up to 1100 deg/cel. whilepyrometer is a non contact measuring device which can be used up to 1100 deg/cel.both are best according to the application 

typical loop drawing of a simple feedback control comprising of one transmitter and one control

0 Answers  

---

A DP Endress and Hauser flow transmitter is always tripping pump at low flow. set point is 74 cubic meter/hr. Thorough impulse line flushing and zero calibration has been done, yet problem persists. What do you think is the problem and how do you rectify this fault?

5 Answers  

---

How digital input and digital output 's are working in dcs

0 Answers   BBV, Indiabulls,

---

How will you calibrate PID controller? explain with example.

0 Answers   Jacobs, Sirte Oil Company,

---

what is the difference between two wire transmitter and 4- wire transmitter

3 Answers  

---

What is the use of valve positioner?

1 Answers   CCIE,

---

Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks

0 Answers  

---

Why we use 4 to 20 mA, (This is International Standard) instaed of this can we use 4-16, or 4-24 or 3- 15 or any other range

13 Answers   ONGC,

---

what is thermo coupler and how it works

2 Answers   Tisco,

---

how can we calibrate RADAR LEVEL transmitter 0% to 100%

3 Answers   Chevron Phillips, Honeywell,

---

how to write the program for single push button by using ladder diagram

22 Answers   DigiTech,

---

What is offset in a control system.

2 Answers   Sabic,

---