Answer / anil

3.5 core means three core for RYB and half core is for
neutral as per IS-1554(p-1). this is in LT cables only upto
1100vots.

Answer / thiru arasu

We take 3.5cx240sqmm Al cable,it have 3core for R,y,B phases
and 0.5c that is half of the Phase(120sqmm) for neutral.
That is known as LT cables.3C cables are HT cables.

Answer / susheel kumar sharma

when there is balanced load in three core , there's no need to Use more than 3C but if there is unbalanced Load in circuits , there is used 3.5C in which 0.5C carry that unbalance current through it..

Answer / bharani

3.5 core in an armoured cable means, neutral cable will be
half in diameter that of phase cable .This is used in LT
circuit where you may use 3 phase load as well as single
phase load.If the load on three phases is balanced, the
neutral current will be less hence half core for neutral may
be sufficient. But if the load on three phases tends to vary
a lot, then neutral curent may increase and in such cases 4
core cable instead of 3.5 core would be recommended.

Answer / aanchal

Thanks

where induction generator is used ?

1 Answers  

what are the steps involved in generator load test?

0 Answers  

there is a # KVA Transformer of 11 KV/440V, in simple(not use formuia) how can you calculate it's HT & LT side current.

5 Answers   Construction, wbsedcl,

What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.

0 Answers   APTransco,

how you will decide the distance between the power transformer and its fencing

0 Answers  

What is the value of system voltage?

2 Answers   Bhel,

I NEED RRB CHENNAI (JE ELECTRICAL) QUESTION PAPER FOR LAST 5 YEAR AND I NEED RRB (JE ELECTRICAL) SYLLABUS.PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in

12 Answers   DFM, Hindustan Unilever Limited, JE, Pace, RRB,

give me name of current and volatge control device

1 Answers  

What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?

0 Answers  

what shoud be strength and weakness to impress interviewer????????

0 Answers  

In what circumstanced the CT used for protection relay will be saturated?and what will happen to the relay is the CT is saturated?

3 Answers  

what is meant by impedance testing of transformer and why it is used

1 Answers   TATA,