Interested to Buy Any Domain ? << Click Here >> for more details...
what is the significance of 3.5 core cable? or what does this
half core mean and why is it required?
- 5 Answers
- 17250 Views
- I also Faced
- E-Mail Answers
Answer Posted / anil
3.5 core means three core for RYB and half core is for
neutral as per IS-1554(p-1). this is in LT cables only upto
1100vots.
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
Phase control and integral control are used for?
what are the basic insulation levels & what its Unit
how many types control panel of a 132/33 kv substation
What safety precaution are to be taken for avoiding electric hazards ?
1)Explain why the cradle guard is used on railway crossing in overhead line construction?
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
What is meant by short-pitched winding?
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage
