1.type of oil in used in transformer.

Answers were Sorted based on User's Feedback

1.type of oil in used in transformer...

Answer / parth

mineral oil

Is This Answer Correct ?    14 Yes 5 No

1.type of oil in used in transformer...

Answer / karthick

it is a askeral oil or mineral oil

Is This Answer Correct ?    10 Yes 1 No

1.type of oil in used in transformer...

Answer / elavarasu

Mineral Oil

Is This Answer Correct ?    4 Yes 1 No

1.type of oil in used in transformer...

Answer / raju

Transformer oil Asker is the technical word
power oil

Is This Answer Correct ?    5 Yes 5 No

1.type of oil in used in transformer...

Answer / anbarasandurairaj

It a hydrocarbon mineral oil

Is This Answer Correct ?    0 Yes 0 No

1.type of oil in used in transformer...

Answer / vinodbagre

Askeral oil / mineral oil / Transil Oil

Is This Answer Correct ?    0 Yes 0 No

1.type of oil in used in transformer...

Answer / hiral

transformer oil say in technical word power oil.

Is This Answer Correct ?    2 Yes 4 No

1.type of oil in used in transformer...

Answer / dev

Synthetic oil

Is This Answer Correct ?    2 Yes 4 No

1.type of oil in used in transformer...

Answer / shyam

it is known as crude oil

Is This Answer Correct ?    2 Yes 8 No

Post New Answer

More Electrical Engineering Interview Questions

An engineer measures the direct current resistance of a transformer using ohm meter. When he/she takes out one of the leads of the meter, spark comes.. Why ?? This effect is known as...

1 Answers   Saint Gobain,

X is a uniformly distributed random variable that takes values betweeen 0 and 1.The value of E {X3}(x cube) will be.

1 Answers   GATE,

Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???

0 Answers  

Does frequency change with increasing voltage i.e 220v to 11kv? explain if not?

6 Answers  

Energy metering: On the property I am renting, the supply voltage is 2 x 110 volts. These 2 x phases enter a energy meter which then exit the meter to over head lines to my house. Question 1. The meter is single phase 240 volts but is being used as 2 x phase(2 x 110volt), is this acceptable? if not, please give me the reasons. The meter details are as follows: 60Hz 15amp Imax 100 amp Kd 3,6 Wh/R 1 fase 3 hilos Model FX 231. I think it was manufactured in Brasil From this meter, the cables run along over head aluminum conductors,I estimate the cross sectional area to be 25mm diameter, but the neutral is only about 10mm square diameter, which cover a distance of 170 meters and then terminate with an underground cable of 65 meter length, total length = 235 meters. There must be a huge voltage drop over this length. This line is protected with 2 x 200 amp aluminum fuses after the meter, there is no main switch in the distribution board. These 2 phases connect directly onto 2 busbars. Surely the neutral should be the same size as the conductors if not more? Question2. What are your thoughts about this installation, should there be better protection, is the neutral too small? During the night, the lights dim then brighten all the time, this cannot be good for my electrical appliances. In my home, I only have a small electric geyser and fridge, my stove works off gas. But when i use other appliances like the washing machine or microwave oven, the light dim. The internal wiring of this house is done with solid hard drawn copper wires and of course, they have to be under rated. I am a retired electrician by trade, but not on the metering and over head mains side, my experience is on the factory maintenance side of things. Your expertise on these matters will be greatly appreciated. Please inform me how to rectify or make any improvements Kind regards, my power bill is very expensive, so I need to know how to bring it lower. Kind regards, Brian

1 Answers  

Pure inductive ckt takes power from AC when 1. Applied voltage and Current increases 2. applied voltage and current decreses 3. voltage decreases and current decreases please justify

2 Answers  

which transfofrmer oil break down voltage strength get will be more if oil sample taken from bottom of tank or oil sample taken from top of the transfomer tank.

2 Answers   NPCIL,

What if high voltage side circuit breaker of a ehv transformer instead of lvcb? Kindly elaborate.

0 Answers   MSETCL Maharashtra State Electricity Transmission Co Ltd,

when u are given a timer,push buttons and contactor, how do i practically make a star delta control circuit and a direct online control circuit?

1 Answers  

how we sesign the transformer give some specifion regarding design of transformers

0 Answers  

what is the different between counterpoise earthing and pipe earthing?

1 Answers  

what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?

0 Answers   Thermal Systems,

  • Civil Engineering Interview Questions Civil Engineering (5062)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4327)
  • Electrical Engineering Interview Questions Electrical Engineering (16562)
  • Electronics Communications Interview Questions Electronics Communications (3564)
  • Chemical Engineering Interview Questions Chemical Engineering (959)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (214)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (253)
  • Instrumentation Interview Questions Instrumentation (2972)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (90)
  • Marine Engineering Interview Questions Marine Engineering (107)
  • Power Plant Engineering Interview Questions Power Plant Engineering (170)
  • Textile Engineering Interview Questions Textile Engineering (198)
  • Production Engineering Interview Questions Production Engineering (0)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (90)
  • Engineering AllOther Interview Questions Engineering AllOther (1376)