What is applied voltage for meggering a 6600V HT cable
Answers were Sorted based on User's Feedback
Answer / hussain
5KV is sufficient to megger 6.6KV cable, if you want to do
Hi-Pot test use: test KV= 2* rated KV +1
Is This Answer Correct ? | 9 Yes | 2 No |
Answer / abhishek
for meggerirng it,s use 1.5times volt in HT cable.in 6.6kv cable we use 10kv dc.
Is This Answer Correct ? | 8 Yes | 4 No |
How instantanious short circuit current is calculated? its formula?
What is an infinite bus bar?
plz explain TSM and PSM.with example suppose ct ratio is 4000/5 and tsm is .15 and plug is at 3.75 if fault current is 8000A.so how i find relay oprating time.
2 Answers College School Exams Tests, ME,
how to check ac servo motor
In separetly excited m/c,we excite the field by a dc source,what not with ac source?
what are all the daily preventive maintainance carried out in transformer?
Load break swicth maintenance procedure.
If there is no problem with the electronic circuit and regulator then why the motor start rotating at low value of regulator with full speed both at laod and no load??? and if my judgement of circuit is wrong then what is your openion?
PLZ sent the previous year question paper for GET in NHPC on my EMail id ppshanker@gmail.com
How we calucate of DC moter I/AMP?
why battery is connected in parallel ?
what is the electricity