Answer / anand suresh

as no load current is about 4-5%of full load current
magnetisation current would be less than that i.e 2-4%of
full current so maanetisation current would be around 2%of
1000 i.e, 20A

Answer / mohammad farman khan-abu dhabi

same as per load ratio

Why is starter necessary for a three-phase induction motor?

37 Answers   BMM, Essar, Hero MotoCorp, ITI, Maruti Suzuki, Supertech, Watt,

---

what is bus duct and what is differance between bus duct and bus bar

6 Answers  

---

Why indicate only 440V to 3-phase supply.

4 Answers  

---

PRV (Pressure relief valve) Trip with oil splash outside power transformers

1 Answers   Khan,

---

how to find out speed of single phase motor

6 Answers   BARC,

---

why does the time taken for fuse to melt is longer as the wire length increases?

1 Answers  

---

i have a Connected Load of 280KW and Maximum Demand of 224KW to one of SMDB under design with me. which criteria should i consider to design panel and main cables connected Load or Maximum Demand 1)Breaker rating 2)Panel Busbar rating 2)Incommer cable sizing (ignore Voltage drop)

1 Answers  

---

if a 3phase motor runnig in star delta starter with full load of its,and its rated 15 amps.now we conneted over load thermal relay at its main contactor,here what will be our amps sittings?

3 Answers  

---

why we decide alternating wave form in ac system and not in dc system

2 Answers   GMR,

---

how to get electrical supervisour certificate in gujarat

0 Answers  

---

Why fuse is? What will prevent by fuse?

2 Answers  

---

a.)Ammeter and Voltmeter read rms value or avg. value ? b.)What are symmetrical and Unsymmetrical faults?

2 Answers  

---