what is the min and max ohmic resistance for the earthing
rod installed for lighting poles for street light network



what is the min and max ohmic resistance for the earthing rod installed for lighting poles for str..

Answer / sakthi

less than 1ohm

Is This Answer Correct ?    2 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

Due to ferranti effect which power increases at the receiving end?active power or reactive power?

5 Answers  


is power factor correction related with vector group of transformer i.e:Dyn11?

1 Answers  


at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)

0 Answers   Ebrahim Textile, Siemens,


Can u explain : how capacitor act when the supply is given is a.c and d.c. I know that when d.c supply is given then the capacitor charges and becomes open circuited. But please say about when a.c is given. I have seen that when a.c supply is given ,it charges and discharges, But when we plug in capacitor to our daily supply and take it out ,then we join those wires spark will appear,which seems charge is present ,but when a.c is given it should charge and discharge

3 Answers  


what is the minimum winding resistance of 30hp compressor, to run or to switch on

0 Answers  






State kirchoff voltage law?

0 Answers  


what is transient enclosure vltage , very fast transients, very fast transient over voltages

0 Answers  


how we can improve power factor from 0.8 to 0.85 or 0.9 & how we identify its either lag or lead ? thank you

7 Answers  


what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors

0 Answers   Lanco,


Describe how a salient pole / projecting pole rotor differs from a cylindrical rotor and state the application of each rotor respectively

3 Answers  


what are the differences between 'exhaust fan', 'heavy-duty exhaust fan' & 'super heavy duty exhaust fan'. what are their power ratings ?

0 Answers   CG,


Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)