Answer / karthik_elec

we can produce electricty by using solar,tidal,wind,diesal
engine but nuclear ,thermal, geo thermal we canot get
electricty withour water, these nuclear, thermal, geo thermal
is only the source of producing the heat, this heat boil the
water for produce the steam, with out water nuclear, thermal,
geo thermal will not give the electricity,

Answer / raju

by Diesel Engine, Solar, Wind.

Answer / naveed malik

By wind mill,tidal(waves),solar,nuclear,thermal,Geo thermal
etc.

Answer / shiva

yes it is possible by themal power plant

Answer / bgharisha86

yes it is possible by giving more than 500 atmospheric
pressure of air

Answer / surendra

nuclear generation

If the positive terminal of batteries in 125 v dc system is connected to earth what will happen ?

4 Answers  

Why two nos. un-tensioned wires are placed inside the PSC poles used by powergrid in RGGVY works.

2 Answers   Bhel, Power Grid,

In Generator How suction compression power and exhaust works ?

0 Answers   Sify,

Any one can explain if there is any harm from humming noise heard from air circuit breaker : we have 415 switch board having two incomers from transformers 3.3KV/415V , when bus coupler closed, and open one ACB incomer to work in one of the transformers, the current started hunting around 50 Amps, and heard humming noise from the air circuit breaker, although the load current was only 1200 amps while the ACB capacity is 2500 Amps, and the transformer 1600 KVA. The same didn't happen when taken the other transformer offline. Why this humming noise and current fluctuation? is there any implication or danger, bearing in mind that we just returned everything back to normal and stopped the maintenance of the transformer. Shall we go ahead and ignore this noise?

6 Answers  

What is a slack bus?

0 Answers  

Difference between hopkinson and swinburne's test

1 Answers  

When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number

0 Answers   TATA,

hello! sir i did three year of diploma in electrical (2007- 2010) and now i m a student of electrical engineering. sir can i apply for germany visa for study and part tome work over there?

0 Answers  

how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.

0 Answers   Webel,

can we use engine degreaser for electrical motors?

0 Answers  

why AC signals are represented by sinusoidal waveform?WHY other waveforms not used for representation

0 Answers  

How to convert KV into MV in a Transformer?. dont say multification of 1000.pls give practical convertion factor.

2 Answers