I am using Capacitive type level transmitter for measuring oil level in a clos

I am using Capacitive type level transmitter for measuring
oil level in a closed tank (lub oil tank). The txs range is
1500mm, and they do hunt regularly (for about 45mm), can
anybody tell what could be the reason??? or any other type
level tx that could be used to avoid this?

Question Posted / srinivas_ipm@yahoo.com

1 Answers
4985 Views
I also Faced
E-Mail Answers

I am using Capacitive type level transmitter for measuring oil level in a closed tank (lub oil tan..

Answer / yogesh

you also use siemens flange type dp pressure level tx.with
capallaries.

yogeshnature@gmail.com

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Instrumentation Interview Questions

I need to know steps to Calibration Valve Guard......

0 Answers

what is the difference between scaler and vector drive

0 Answers Jindal,

what is pressure control

1 Answers GNFC, IBM, Privi Organics,

How to ensure vibration sensor functioning accordingly.With out using an other sensor.

3 Answers ACC, Oil India,

How hart protocol can be connected with control valves?

0 Answers

how to calibrate steam control valve in steam turbine

0 Answers

few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters

0 Answers Monnet,

What is the difference between fiber optic cable & Ethernet cable

2 Answers BEMCO, CCC, Pidilite,

how bolometer is used in temperature measurement ??

1 Answers

(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.

0 Answers ADMA OPCO,

What is DCS?

5 Answers Adani,

we have LPG spherical Tank and we want to install DP Xmtr for level measurement.below are the physical measurements Total height of tank is 1850 mtr but 0% level is 1000mm above bottom and 100% level is 450 below upper side.What is the LRV and URV and please mention the formula .The SG of LPG is 0.53 and Wet Leg method will be used.

7 Answers

For more Instrumentation Interview Questions Click Here