Answer / waqas ali

Two methods:
1. Using multimeter which should have a built in provision
for checking of diode.
2. Connect +ve terminal of a 12VDC power supply to Annode
of diode and -ve terminal to the cathode. Check with
multimeter the voltage drop across diode. If it is ~0.7V,
then it's OK otherwise it's faulty.

Answer / surath

In multimeter there is a provision for checking diode
having diode symbol.By putting the two ends inside the
points if a continuity sound will come then the diode is
working.

Answer / ganesh

diode is work like a switch as reverse or forword baised we
can check from multimeter in set on resistance in ohm

Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.

0 Answers  

---

radial & axial vibration sensor output voltage is ac or dc volt?

8 Answers   Vedanta, Voltech,

---

what is the meaning of reverse action and forward action of control valve...

9 Answers   Honeywell, Yokogawa,

---

hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.

0 Answers   Jindal,

---

WE Know that different supply voltage of solenoid valve like 24,110,220 etc..how we check the solenoid supply is 24v or 220 NOTE: No specification at device.

2 Answers   OMV,

---

What is the diffirence between Earth and Neutral and What is the required normal voltage between earth and neutral

6 Answers  

---

pressure switch range 0 to 2bar.i have to install from ground level to 5 meters height.what is the formula the to increse the range ? and every 1 meter how much pressure should be add ?

3 Answers  

---

what is diffrence between cascade & three element system.

3 Answers  

---

how to calculate interface capelary level transmetar lower S.G.0.54 and uper S.G. 0.26 and h=490 mm

3 Answers  

---

In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?

0 Answers  

---

What properties or parameters to be taken into consideration for protection while selection of Dcs controller.

1 Answers   JPL,

---

I am an intru engg frm pune n completing mba marketing in may 2010, what kind of profile would best suit my educational qualifications??? Also, i will move to US in jan 2011, so this job experience should count Over there too 'coz i want to continue workin even there....

1 Answers  

---