Answer / pal

its been not worth that m answering in 17, u cmpltd ua engg. as well as ua mba and movin to US , whats wrong with u fella, nobody can give u the ans. coz its ua lyf n u should take ua own decision to conquer the world..

given a processor batch of 1000 resistors moving on the conveyor belting in a large factory. the resistors is value at 10k ohms each but when the resistors reach the quality control, some of the resistor has been rejected caused by failure in manufacturing.the high quality measurement is used to determine the failure. describe the instrumentation terminology in measurement of a system above with explaining the important in:- -reliability -sensitivity -repeatability -precision -range -resolution -linearity -hysteresis -error -accuracy (answer must related to the scenario above)

0 Answers  

---

With N nodes and B branches what will have a network ???

0 Answers   BSNL,

---

I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID

0 Answers  

---

how to install the Ph and Conductivity analyser? is there are any procedures which has to be maintained.

2 Answers  

---

Basic working principle of control valves

1 Answers  

---

I am working in a process industry, in that there are several sections devided in the SCADA screens and individual sections may START independently. But sometimes i am facing problem i.e, if section 2 Stopped by the operator immediately Section 1 or Section 3 or Section 4 is getting stopped can you expain the reason behind this?

5 Answers  

---

On drum level, why we are using air to close Control valve?

4 Answers   L&T,

---

I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration  So is there any causes biside this or  any  permissives ?

0 Answers  

---

what is puling in n pulling out in flame scanner system?

1 Answers  

---

DC motor and DC Drives working funda?

1 Answers  

---

what is 24vdc live and dry supply

0 Answers  

---

if we put any thermocouple on a table in a room without any connection,what temperature should it show.

3 Answers  

---