what is Fault level? why it is calculated? how will u decide
same for our plant?
No Answer is Posted For this Question
Be the First to Post Answer
how did i get the competency certificate as electricle supervisor. iam completed my b.tech.but i dnt have any experince, this certificate is required for applyng ongc mangement trainees. what should i do sir please suggested me
We have 3 Gensets 1.500kva,2.380kva,3.250kva How can we connect in common busbar&we have variable load.
in HVDC transmission system ,monopolar link has one conductor usually a negative polarity and use ground or sea return ?through negative polarity we could pass electricity or not yes means how it is possible
what objective books are good for preparing for PSU's?
Pure inductive ckt takes power from AC when 1. Applied voltage and Current increases 2. applied voltage and current decreses 3. voltage decreases and current decreases please justify
What is Neutral Transformer? what is the use of this?
What is the main feature of v/f control?
How to write a progrramme to turn ON and turn OFF a motor with a single push button in AB?
2 Answers HCL, Torrent Pharma,
What is meant by CFL & PL lamps
what happen to the voltage and current in all phases when an earth fault occur in a phase in three phase three wire system(delta connected)...
Z transform is use when system is not a) converges b) diverges
In the diesel generator wihch type of power we can get it ? Like AC / DC
2 Answers Aditya Birla, Indian Steel, PTPS,
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)