in HVDC transmission system ,monopolar link has one
conductor usually a negative polarity and use ground or sea
return ?through negative polarity we could pass electricity
or not yes means how it is possible



in HVDC transmission system ,monopolar link has one conductor usually a negative polarity and use ..

Answer / sunil

because,negitive polarity reduce corona effect and less
interfearence in communication lines

Is This Answer Correct ?    24 Yes 5 No

Post New Answer

More Electrical Engineering Interview Questions

why near the transformers, the Jelly(small white colored rocks)are poured.and what are conditions for that?

3 Answers  


what is Anti-pumping?

0 Answers  


what will happen if OLR CT in all phases are short circuted

0 Answers   Indfrag Limited,


how terminal voltage increases when load is capacitive (leading pf load)? (explain practically what is happening, not using phasor diagram

1 Answers  


hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...

0 Answers  






There are two nos of 33Kv/11Kv 5MVA transformers conecting through HT cable from substation having metering at substation itself.One transformer used at a time another remains stand by.Further 11 nos of 11Kv/440V transformers are attached on it and each transformer is having its own Power factor correction panel.Now one 33/11Kv transformer at no load condition/Stand by condition is having power factor in leading side upto 0.21 and while when another tranformer at same situation have power factor in lagging 0.42. Now one thing is clear that transformer one is having 1.5 Km long 33kv cable due to that PF goes in leading side and another is having only 250 mtr length remains him lagging. Now i want to know that how i can maintain the Power factor at no load/ stand by position though both are behaving in seperate manner.

1 Answers  


Define phase cross over?

0 Answers  


describe the Operation of induction generators from bus bars

0 Answers   AMIE,


How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?

0 Answers  


what is the Transformer Impedence?How can calculate?

0 Answers  


can we done C.T.sc at output? if yes y,if no y?

3 Answers  


why bucholtz relay placed inclined in transformer?

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)