Answer / wareagle

You are not required to use 125% for motors. The NEC says
that the breaker rating can be up to 250% of the motor FLA.

How does a clampmeter measures dc current

1 Answers  

---

In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem

0 Answers  

---

Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?

0 Answers  

---

what is PWM in IGBT and how it works for drive.?

0 Answers   BRG,

---

How to calculate the lighting load & power load requirement by knowing area of building/room. Is there any thumb rule?

3 Answers  

---

what are the losses of capacitor??

1 Answers  

---

which is batter in construction job,ELCB or RCCB?

7 Answers   HCC,

---

WHICH SUPPLY IS BETTER FOR 4 MW LOAD. 1)TO TAKE NEARER AVAILABLE 11 KV SUPPLY OR 2)TO TAKE 33 KV SUPPLY WHICH IS AVAILABLE AT 10 KM DISTANCE BY INVESTING NEARLY 50-60 LACKHS

1 Answers  

---

how many minutes or seconds taken by the transmission of electrical power from generating end to distributing end?

3 Answers  

---

Why we Do not connect the windings of the motor in delta? & what would happen if we do that? I mean the winding themselves not the three lines that are coming to the motor?

1 Answers  

---

In generating stations which we generate current or voltage if it is voltage then how it will convert to current and power?

2 Answers   NIT,

---

what is induction relay

1 Answers  

---