Answer / m.anandamani

The power is combination of voltage and current.It is
denoted by "P" and the unit is Watt.

Single phase:

Total power= Voltage x Current

Three phase:

Total power= 1.732 x Line voltage x Line current x P.F

Answer / pijush

as above

UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?

0 Answers  

---

what is humming noise and wha is the reason to develop humming noise in a mv pannel ?

2 Answers   HPL,

---

What is slip in an induction motor?

0 Answers  

---

what is armature reaction?explain in simple words?and what is its infleunce on dc motor

16 Answers  

---

why middle phase should used for earth fault and other phases used for over current in overcurrent and earth fault relay?

7 Answers   ABB, ONGC,

---

---

the need of star to delta anddelta to star

2 Answers  

---

how to fit 3 HP crompton gear motor with conveyor with the use of staring delta starter or ordinary starter?

0 Answers  

---

Difference between low impedance and high impedance Restricted Earth Fault

0 Answers  

---

can any one provide me a connection wiring diagram for a DG set control panel along with BOM?

0 Answers   Omaxe,

---

in a refinery one motor is suddenly stoped. what will do how can i findout the problem explain step by step

2 Answers  

---

WHAT IS THE DIFFERENCE BETWEEN KW AND KVA ?

10 Answers  

---

in case of induction motor when overload condition or any short ckt. why stator winding burn not to be rotor winding

2 Answers  

---