Answer / sudharshanrao

calibration is the varification and error correction of
secondary standard, comparing with master or primary
standard(instruments).

Answer / jigar anadkat

Calibration means "TO COMPARE WITH STANDARD". Let it be
calibration of DPT, PT, etc.
Any instrument which is CHECKED and RECTIFIED against the
known standard is called the calibration.

Answer / a.c.subash

Calibration is the calibrating the instrument with the
Master Instrument which is calibrated against National
Standards and the Value is fed in the Test Instrument.

Answer / thriambak

Calibration is nothing but comparing the standard value
with the unknown value inorder to find the specifications
or details of the unknown value.

Answer / vicky

calibration is defined as the procedure for measurement

what are the different types of terminal lugs used for wiring termination?

5 Answers   Yokogawa,

what is meant by turn down ratio?

3 Answers   Avant Garde,

what is PM/CM/RCM?

2 Answers   Emco,

I have a steam flow DP transmitter that has output swinging. Steam valve is in manual.I have good steam pressure. The impulse lines have steam tracing on them. The steam tracing has a hole in it that is blowing raw steam on the high side impulse line only. Could this be causing the swinging?

1 Answers   Honeywell,

I have transmitter of range -20 to -5 kpa.if it is possible to zero trim with atmospheric pressure,means HP and lp having no pressure...what will get after zero trim and it is the right way.....plz give me reply ....

3 Answers   KOC,

what is Pre- commissioning.

5 Answers   Saipem, Takreer,

What is the reason PT speed not incresed in gas turbine?

0 Answers   ROC,

What is sensitivity of K type thermocouple? Is polarity important in thermocouple connections?

3 Answers   Honeywell,

any one suggest me how to calculate percentage of air leakage with formula,

0 Answers   SSL,

where cascade loop use ?

0 Answers   KNPC, KOC,

How do you calibration D.P transmitter? ?

2 Answers   Power Plant,

Can you explain drawbacks between P,I,D & PID controller

1 Answers   JSW, Priya Cement, TPL,