Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sudharshanrao
calibration is the varification and error correction of
secondary standard, comparing with master or primary
standard(instruments).
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
What is the purpose of the analyzer in petrochemical plant?
what is function of SCADA , and how is it work, explain with difination
How does temperature bath work? How does coil gets heated only by applying some current?
what is isloted barrier how it works and what are the main purpose.how it make safe area.
Draw symbols of the following :
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
define feed forward control loop with example and drawing?
What is first echo & echo window in radar type level transmitter?
TECHNICAL/ARTITUDE
ORP sensor working principle?
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
TEMPERATURE VARIATION FOR FREQUENTLY.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
