Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vicky
calibration is defined as the procedure for measurement
| Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
Using your own examples solve a problem involving normal table. (experimental method and analysis)
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
Give Detail information about plc,dcs,and scada system?
Hi, I am Newely Joined in Construction company instrument engineer? Any one can Plz tell me How can I advanced preparation for Releated Engineering and construction Documents?
why I need valve guard and whats different between guard and positioner ??
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
What is the GK Value in Flowmeter?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
Explain an adaptive / self-tuning controller’s major draw card.
What are the uses of orifice plates?
Explain about the leakage class of the control valves
what can of fault ofently come in vibration mesurement?
