Answer / k.prakashchandra

If you want to measure ER of particular electrode ,you have
to disconnect it , to avoid the influence of other electrode
connected to the same equipment.If the cables are connected
in parallel ,the load sharing is inverse to the resistances
of cables so that the voltage drops in the cables are equal

What is the difference between SSR drive& AC drive?

1 Answers   ITC Infotech,

---

AC voltage only create magnetic flux in coils, but in Solenoid coil how 24V DC volt create flux and pick the plunger

5 Answers  

---

What will happen if i connect two 3-phase tranformers secondary supply on one bus bar that is R-Y-B-N?

2 Answers   GMR,

---

in our sub station why we step down firstly 33kv\11kv then 11kv to 430v. can we direct step down 33v to 430.v.

7 Answers  

---

hi frnds.....anyone get any reply from HPCL. I HAVN'T.....B,COS written will b on FEB 17 th.

1 Answers   HPCL,

---

ups battery design formula

0 Answers   Amara Raja,

---

what are fluorescent lamps (fluorescent fixtures) & what are incandescen lamps (incandescents fixtures) ? differences between these two ?

1 Answers  

---

what is bus coupler? and how many type? which one is big advantage ?

2 Answers   Essar,

---

Which type of material used for fuse wire & solder wire.

13 Answers  

---

how nautral is provided for return path is 3 phase induction motor

0 Answers   SNGPL,

---

how we can to the synchronization in transformer. What are the conditions for that.

1 Answers  

---

What happens to an electric motor if it has poor or no ventilation. Will it burn out? If it will, how long it will run before it burn out?

5 Answers   GMC,

---