Interested to Buy Any Domain ? << Click Here >> for more details...
Which type of material used for fuse wire & solder wire.
- 13 Answers
- 62581 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / sushama patil
Fuse wire is made of the material having low melting point
| Is This Answer Correct ? | 226 Yes | 32 No |
Answer / rajashekar
Fuse wire and solder wire made for Tin And Lead used.
| Is This Answer Correct ? | 137 Yes | 17 No |
Answer / ashwin
An alloy of tin and lead is used. (67%lead, 33%tin)
| Is This Answer Correct ? | 111 Yes | 15 No |
Answer / melbin c varghrse (m.tech powe
An alloy of tin and lead in the ratio 40:60 is used to make
fuse wire and an alloy of tin and lead in the ratio 60:40 is
used to make solder wire.(solder wire melts easily than fuse
wire since tin is more)
| Is This Answer Correct ? | 39 Yes | 9 No |
Answer / ravi singh
fuse having a high resistance and low melting point..
| Is This Answer Correct ? | 43 Yes | 15 No |
Answer / ajith
Fuse wire is no made up of lead tin alloy solder is made up of lead tin
| Is This Answer Correct ? | 22 Yes | 13 No |
Answer / soumyaranjan
The fuse wires are bare wires made of easily melting materials having high specific resistance I.e. gold,silver,lead,tin alloy, tinned copper wire etc. Mostly standard alloy 63%tin and 37% lead , fuse wires are used for low current upto 5amperes and tinned copper forany value of currents.
| Is This Answer Correct ? | 5 Yes | 5 No |
Answer / harsh
for fuse wire solid copper/aluminum wire is used and for
solder lead
| Is This Answer Correct ? | 28 Yes | 29 No |
What is the basic rule for block diagram reduction technique?
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
v/f drive basic princeple
what will happen if phases are not shorted with neutral in transformer impedance test? and if neutral is not connected with ground?
advantages of vvvf drives over non vvvf drives for EOT cranes
What conditions are required for a transformer to operate at low frequencies ?
Where is servomechanism used?
how to calculate total load in a villa?
How would you calculate power loss in a resistor?
what is interpose vt where it is used and y it is used?
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
