what is bus coupler? and how many type? which one is big
advantage ?

Answers were Sorted based on User's Feedback



what is bus coupler? and how many type? which one is big advantage ?..

Answer / rsbangra

as per question bus coupler is couple two bus systems .
as otherways if two sourse of supply at same voltage same
frequency and and same phase sequence we can couple in
running and off condition of one source.
advantage
we can parralle two lines by bus coupler
we shift load one bus to other bus.
we can charge both bus by one sourse in case of one sourse
failure.

Is This Answer Correct ?    9 Yes 0 No

what is bus coupler? and how many type? which one is big advantage ?..

Answer / aamirali

Bus Coupler is used to connect the two or more incoming and outgoing buses (Same voltage & frequency)and under the abnormal conditions we can shift the load on an other bus, without any interruption this is big advantage .
Types of Buses:
1. Fixed v & angle, vary P & Q
2. Fixed P & Q, vary V & Angle
3. Fixed P & v, vary Q & Angle

Is This Answer Correct ?    3 Yes 3 No

Post New Answer

More Electrical Engineering Interview Questions

In 3 phase induction motor 1hp current rating is 1.5 amps constant ? is correct or not ?

4 Answers   TATA,


What is the full form of GSL wire

7 Answers   Bhel, GSL,


1.What is effect of capitance in transmission line? 2. After raising the voltage at receiving end what will be happen? 3.how we nullify or control the raised voltage at receiving end?

3 Answers   NTPC,


what r the types of transmission line?

28 Answers   DIET, RRB, WAPDA Water and Power Development Authority,


What is an Automatic Voltage Regultor & what is its use? What are the general componets we use to design an Automatic Voltage Regulator..What are the factors to be considered for its design?

3 Answers  






What is the capacitance values of 132,220,400 & 765 kV current transformer

0 Answers  


Why the outpet og DG is 415V not 440V?

1 Answers  


WHEN SINGLE PHASE SUPPLY AS 220V, WHY THE 3 PHASE- 4 WIRE MEASURED AS 440 VOLTS INSTEAD OF 660 VOLTS (220 VOLTS PER PHASE i.e 220x3 = 660 volts ).

1 Answers  


What was your role in the silicon evaluation/product ramp? What tools did you use?

0 Answers   Intel,


Different between megger and contact resistance meter

3 Answers  


In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?

0 Answers  


is emf is indued if dc is passed through coil

5 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)