how to work current transformer and potential transformer
Answer / gulwinder singh
current transformer steps up the voltage level thus current
come in the range of measurement, we can measure the
current easily
potential transformer steps down the voltage level thus
voltage come in the range of measurement, we can measure
the voltage easily
| Is This Answer Correct ? | 14 Yes | 3 No |
1 unit or 1 kwh means how much kva
What is difference between 220v/50Hz & 120V/60Hz?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
What is Ten Delta Test ?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
what is automatic voltage regulator and it is used?
Current Transformer's star point must face the protected object for the relay operation?
Difference between single phase and three phase?
How we calculate DC inducation moter Amp? Sir pls give me formula......
What happen if 1200KW/1500KVA alternator runs at no load and high R.P.M.for one minute?
What is the main feature of v/f control?
How to conduct the Magnetic Balance test on Power Transformer?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)