three owners X, Y, z owned some tractors with them, on the first month x gave away the same amount of tractors to y and z ( as much as they possed), similarly in the 2nd month y gave of to x and z similarly by third month z gave to x and y. after this all X, Y, Z had 24 tractors each.
Answers were Sorted based on User's Feedback
Answer / ravi chandra
Actually each has 24 at the end.
In the last transaction Z gave its tractors to Y and X i.e, X and Y's amount has been doubled
X=12; Y=12; Z= X+Y+24 =48;
and now the transaction happened by Y
similarly
X=6; Z=24; Y= X+Z+12 =42;
then the transaction happened by X
Y=21; Z=12; X= Y+Z+6= 39;
So, at the beginning X has 39, Y has 21, Z has 12.
| Is This Answer Correct ? | 21 Yes | 0 No |
Answer / sasireka
In beginning X had 42 tractors and Y had 24 tractors and Z has 6 tractors.After X had given as much as they possessed then X has 12 tractors,y has 48 tractors and Z has 12 tractors..after Y had given x and z as much as they possessed then x,y an z has 24 tractors
| Is This Answer Correct ? | 5 Yes | 13 No |
Why Dyn11 Transformer is selected for distribution transformer?
3 Answers JK Associates, MSETCL Maharashtra State Electricity Transmission Co Ltd,
what is the use of breather in transformer?
LT cable fault checking instrument is available? where and how to get it.
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
what will happen if ac motor given dc supply?
What is best method of Calculating Short Circuit current in power system network.
how choose conductor&depending upon load
WHY DOES NEUTRAL DO NOT CARRY EVEN THOUGH IT CARRIES RETURN CURRENT?
what is meant by Hrc fuses.?In the distribution system different rating hrc fuses are used for tranformer(which is 3k,6k,10k,15k etc).what is k?.plz any brother tell me about k?
Slow acting fuses are most often used for which application a) Lighting circuit b) heating circuit c) Motor D) Radar circuit
why rating of motor in HP?
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)